Gutter Heat Cables and De-Icing in Pittsburgh: Worth It?
Early October is when to decide about heat cables, because they need to go on before the first freeze and the people who install them are booked solid by Thanksgiving. Here's what they do, what they don't, what they cost in Pittsburgh, and the houses where they're the right answer versus the ones where they're an expensive patch.
What a heat cable does
A self-regulating heating cable runs along the roof edge in a zigzag, then down the gutter and inside the downspout to below the frost line. It doesn't melt the snow on the roof. It keeps a channel open in the ice at the eave so that meltwater has somewhere to go instead of backing up under the shingles, and it keeps the downspout from freezing into a solid column that splits the elbow. That's the whole job, and it's a useful one.
What it doesn't do
It doesn't stop ice dams forming. An ice dam is made by heat escaping the attic, warming the roof deck, melting the snow from underneath, and the meltwater refreezing at the cold eave. The cable makes a gap in the dam; the dam still forms on either side. If the attic problem is bad — a Cape Cod with knee walls and no insulation behind them, a 1920s house in Highland Park with a warm third floor under the slate — the cable is treating the symptom at $200 a winter in electricity. Attic air-sealing and insulation is the fix, and the Pennsylvania PUC's energy programs and the local utilities point at rebates for it most years.
Where they help and where they don't
Where cables are the right answer
- A north-facing eave that never sees the sun, on a house where the attic is already reasonably insulated. That's most of the north side of Mt. Washington and the north-sloping streets of the North Hills.
- Roof valleys that dump into a gutter and refreeze at that spot every winter.
- Downspouts that freeze solid every year and split at the elbow by March.
- Box gutters on 1900–1930 homes. A built-in gutter holds a lot of ice, and a cable in the trough keeping the outlet open through February is the cheapest way to protect a lining and a cornice. Details on the box gutter page.
- A low-slope roof section — a porch or an addition — where meltwater can't get away fast enough.
Where they're the wrong answer
- A house with a warm attic and ice dams along every eave. Fix the attic; the cable is a bandage on a problem that will also be rotting the roof deck.
- A gutter that already sags or leaks. The cable will keep water moving into a gutter that's dumping it at the foundation. Repair first.
- A house where the gutters are full of leaves. A cable buried in wet leaves heats leaves.
What it costs
| Item | Typical Pittsburgh range |
|---|---|
| Self-regulating cable, installed, per foot of eave | $12 – $22 |
| Downspout run, per downspout | $60 – $120 |
| Dedicated outdoor circuit with GFCI (electrician) | $250 – $600 |
| Thermostat or snow/moisture controller | $100 – $300 |
| Typical single north-facing eave, 40 ft, two downspouts | $700 – $1,300 |
| Whole house, 160 ft | $2,200 – $4,000 |
Running cost is the number people skip. A 100-foot run of self-regulating cable draws roughly 500–800 watts when it's cold, and if it's on a plain switch it runs from November to March. At Duquesne Light's residential rates that's $150–$300 a winter. A controller that only turns it on when it's below freezing and there's moisture on the roof pays for itself in two winters.
Self-regulating versus constant-wattage
Buy self-regulating. It draws less as it warms, can be cut to length, and can overlap itself without burning out. Constant-wattage cable is cheaper at the hardware store and is the kind that starts fires when someone bunches it in a downspout. Either kind needs a GFCI-protected outdoor circuit, which is an electrician's job; the Consumer Product Safety Commission's guidance on roof and gutter de-icing cables is worth five minutes before anyone plugs one into an extension cord through a window.
Installing it right
The cable zigzags along the roof edge from the eave up to about a foot above the exterior wall line, so the channel it melts reaches the warm part of the roof. It runs the length of the gutter, then down each downspout to the bottom — past the frost line if the downspout goes underground. Clips hold it to the shingles without nails; on slate it's clipped to the gutter and the roof clips are avoided. And it goes on clean gutters, after the November leaf drop, which is why the timing matters: book the cleaning and the cable for the same week in late November.
The order of operations
If you're weighing this, do it in this order: fix any gutter that leaks or sags, extend the downspouts, get the attic insulation checked, and only then price a cable for the specific eaves that still ice up. The full winter to-do list is in winterizing gutters in Pittsburgh, and if last winter's ice already did damage, the gutter repair page covers what a re-hang and reseal cost.
Need gutter work in Pittsburgh?
Call for a free estimate. Mon–Sat 7am–7pm.